CMCP565 Thermocouple Transmitter

Home > Transmitters (Din Rail) >

CMCP565 Isolated Thermocouple Temperature Transmitter

Alternative Views:

Our Price: $455.00

Product Code: CMCP565

Input

Range:

Alarm Module

Description

Technical Specs

The CMCP565 Isolated Thermocouple Temperature Transmitters are compatible with J and K type thermocouple inputs, and they provide a 4-20 mA output proportional to the overall measurement. Each unit processes the signal to determine overall amplitude, and outputs a 4-20 mA dc current that is proportional to a user specified range such as 0-250 Deg. F. Combining transmitters with an existing PLC or DCS system results in a high density, low cost monitoring system.

Alarms relays and trip multiply are available with the Monitor version.

Alarms - The CMCP500A Series Monitors have two independent set points, with LED alarm indicators and output relay contacts (Alert and Danger). Set points are adjustable via potentiometer, from 0 to 110% of full scale. Each has an adjustable delay of 1 to 10 seconds. SPST Relay contacts are rated 5 Amps @ 30 Vdc or 250 Vac for resistive loads.

Relay contacts can be independently configured by the user for either Normally Open (NO) (Standard) or Normally Closed (NC) operation. Relays are normally de-energized and can be configured for latching or non-latching (standard) operation. Latched alarms may be reset locally or by remote contact closure.

Trip Multiply - The monitors have set point multiplication of 3X via contact closure (2X available). To avoid tripping the alarms during machine start-up.

Custom Input and Output Configurations Available On Request

Buffered Output:
A BNC connector mounted on the front of the unit provides access to the buffered transducer output signal. This includes both the unfiltered vibration signal, and the DC bias voltage. Portable test equipment or analyzers like SKF-CM's Microlog^TMcan be connected to this output without disturbing other system outputs.

Fault Detection:

On board fault detection circuitry continuously monitors the transducer for normal operation. If a fault occurs, the output current is reduced to 2 mA to indicate the fault to the readout system. A red LED on the front of the unit is turned on to provide a local indication of the fault.

Documents Available:

Browse for more products in the same category as this item:

Transmitters (Din Rail)
Temperature
TSI Systems

	CMCP272 Stainless Steel Wire Clips $25.00
	CMCP265SS NEMA 4X Stainless Steel Termination Boxes $325.00
	CMCP260SS NEMA 4X Stainless Steel Enclosures $250.00
	CMCP310SS NEMA 4X Stainless Steel Switchable BNC Junction Boxes - Indoor/Outdoor Locations $650.00
	CMCP300SS NEMA 4X Stainless Steel BNC Junction Boxes - Indoor/Outdoor Locations $350.00
	CMCP570 Solid State Temperature Transmitter $455.00