|
|
|
|
|
|
CMCP-701 1" Piloted Spot Reamers
|
Our Price: $175.00
|
|
|
Piloted End Mill Aircraft Spot Reamers are used to mill a 1" (2.54 cm) smooth flat area on bearing housings. The flat area will accept a stud mounted accelerometer or a glue (epoxy) mounted with an STI Accelerometer Mounting Pad. The 7/32" drilled hole can then be tapped with a 1/4" x 28 UNF starter and bottom tap for stud mounted accelerometers.
|
|
|
|
|
|
|
|
|
|
|
|
|
CMCP-710 1" Spot Reamers and End Mills - Ordering Page
|
|
|
Indexable Counter Bores are used just like the less expensive spot reamer to mill a 1" (2.54 cm) smooth flat area on a bearing housing to mount an accelerometer. Their major advantage is that the have replaceable (indexable) Titanium Nitride cutting edge inserts. These inserts are triangular with three cutting edges per insert. Each cutting surface is very durable allowing greater machining capability over the less expensive spot reamer. Each kit comes complete with counter-bore, 10 ea. inserts, pilot, insert screw and insert key.
|
|
|
|
|
|
|
|
|
|
|
|
|
CMCP-720 Accelerometer Mounting Tool Kits - Ordering Page
|
|
|
Piloted End Mill Aircraft Spot Reamers are used to mill a 1" (2.54 cm) smooth flat area on bearing housings. The flat area will accept a stud mounted accelerometer or a glue (epoxy) mounted with an STI Accelerometer Mounting Pad. The CMCP-720 is available in English and metric versions. Drill, pilot, allen wrench and end mill are included in each kit. The drilled hole can then be tapped stud mounted accelerometers. Includes, Endmill, Pilot, Drill, Allen Wrench and Tap.
|
|
|
|
|
|
|
|
|
|
|
|
|
CMCP-730 5/8" Counterbore Kit
|
|
Our Price: $180.00
|
|
|
The New CMCP730 5/8" Diameter End Mill Kit makes it easier and faster to mount CMCP1100 Low Cost Industrial Accelerometers. As the CMCP1100 Accelerometer has a 1/2" (12.7 mm) footprint a smaller end mill can be used rather than the traditional 1" (25.4 mm) diameter units normally provided. The CMCP730 End Mill Kit with a diameter of 5/8" reduces the total surface area to be milled by over 50%.
|
|
|
|
|
|
|
